JVC UX-QX3WA Service Manual page 23

3.2.9 Removing the switch board
(See fig.6 and 16)
• Remove the CD cover.
(1) Remove the card wire from connector
board from bottom side of CD mechanism assembly. (See
fig.6)
(2) Remove the wire from soldered section p of switch board.
(3) A switch board is raised pushing the hook q of CD mecha-
nism assembly in the direction of an arrow, and it removes
from the part r.
Reference:
• The wire should hook to part s after attached switch board
to CD mechanism assembly.
• Hook q of CD mechanism assembly should lock by glue.
3.2.10 Removing the motor
(See fig.16 and 17)
• Remove the CD cover and tray assembly.
(1) Remove the wire from soldered section p of switch board
from bottom side of CD mechanism assembly. (See fig.16)
(2) Remove the belt from motor pulley from top side of CD
mechanism assembly. (See fig.17)
Caution:
Be careful not to make grease adhere to a belt.
(3) Remove the two screws J attaching the motor to CD mech-
anism assembly, and then take out from bottom side of CD
mechanism assembly. (See fig.17)
Reference:
The wire should hook to part s after attached the motor to CD
mechanism. (See fig.16)
Switch board
CN602 of switch
Soldered
section p
r part
s part
Hook q
Wire
Fig.16
CD mechanism assembly
Motor pulley Belt
Fig.17
CD mechanism assembly
J
(No.MB574)1-23