JVC UX-QX3WA Service Manual page 22

3.2.8 Removing the feed motor
(See fig.13 to 15)
• Remove the CD cover and traverse mechanism assembly.
(1) Remove the yellow wire and white wire from soldered sec-
tion m of the CD servo board at bottom side of traverse
mechanism assembly. (See fig.13)
(2) Remove the screw G attaching the plate, and the take out
the feed gear. (See fig.14 and 15)
(3) Remove the screw H attaching the feed motor, and then
take out the feed motor. (See fig.15)
Reference:
A time of feed motor attachment, the wire should through part
n of spindle base. (See fig.15)
1-22 (No.MB574)
CD servo board Traverse mechanism assembly
Fig.13
G
Plate
Traverse mechanism assembly
Fig.14
H
Feed gear Feed motor
Traverse mechanism assembly
Fig.15
Wire(yellow)
Wire(white)
Soldered
section m
n part