JVC UX-QX3WA Service Manual page 19

3.2.3 Removing the LED assembly
(See fig.5)
• Remove the CD cover and tray assembly.
(1) Remove the double face tape attaching the LED assembly
from top side of tray assembly, and then take out the LED
assembly.
3.2.4 Removing the traverse mechanism assembly
(See fig.6)
• Remove the CD cover.
(1) Remove the four screws C attaching the traverse mecha-
nism assembly from bottom side of CD mechanism assem-
bly.
(2) Remove the card wire from connector
board, and then take out the traverse mechanism assem-
bly and CD servo board together.
Reference:
When attach the traverse mechanism assembly, the wire
should through part b.
CN602 on CD servo
Tray assembly Double face tape
Fig.5
CD mechanism assembly
Slot b CD servo board
C
Traverse mechanism assembly
Fig.6
LED assemlby
C
CN602
(No.MB574)1-19