Assembly Instructions - Spirit 16007602850 Owner's Manual

ASSEMBLY INSTRUCTIONS

!!ATTENTION: IMPORTANT UNPACKING INSTRUCTIONS.
PLEASE READ BEFORE UNPACKING YOUR FOLDING TREADMILL!!
Serious injury could occur if this folding treadmill is not unpacked properly.
There is a Velcro strap installed around the treadmill base that prevents the treadmill from
unfolding accidentally during shipping. If this strap is not removed properly the treadmill could
spring open unexpectedly and cause injury if someone is standing near the treadmill when the
strap is removed.
To ensure your personal safety during removal of the shipping strap please make sure the
treadmill is positioned flat on the ground, in the orientation it would be in if you were using the
treadmill. Do not turn the treadmill up on its side while removing the shipping strap. This could
cause the treadmill's folding mechanism to spring open. If the end of the Velcro strap (that you
need to grab to remove it) happens to be under the treadmill deck, reach under the deck to grab
it, but do not tilt the treadmill up to gain access to the strap end.
Cut the banding straps with a short box cutter (razor knife); separate the carton from the one
underneath it by prying up on the staples (if applicable). Pull the carton over the treadmill parts
and locate the hardware pack. The hardware pack is separated into five sections; one section
containing tools and four sections labeled steps 1-4 which contain the hardware needed for
assembly of each step. The assembly steps below are numbered one through four and
correspond to the hardware in the numbered sections of the hardware pack. Remove only the
hardware for the step you are currently assembling to avoid confusion and mix ups.
Then remove the treadmill from the carton and lay it on a level surface.
ASSEMBLY TOOLS
#96. Combination M5 Allen
#122. Phillips Head
Screwdriver
Customer Service 1-888-707-1880
Email: customerservice@dyaco.ca
Wrench
#97. M6 L Allen Wrench
9 Dyaco Canada Inc. 2016