Vertically Mounting The Ap With Dc Supply To A Pole - Cisco Catalyst 9124AX Series Hardware Installation Manual

Vertically Mounting the AP with DC Supply to a Pole

Materials Required
Grounding rod
10-mm box-end wrench or socket set
Procedure
Step 1 Use the mounting bracket as a template to mark six screw hole locations on the mounting wall. The mounting
bracket screw hole locations and the dimensions of the mounting bracket are shown in .
Step 2 Use six screws and, if required, wall anchors to attach the mounting plate to the mounting surface. These
screws and anchors are to be sourced independently.
Note
Note
Step 3 Screw an M6 x12–mm bolt into each of the four support bolt holes on the back of the AP. Do not screw the
bolt all the way in, but leave a gap of approximately 0.13 inch (3.3 mm).
Step 4 Position the AP against the mounting bracket such that the four support bolts on the back of the AP slot into
the keyhole slots on the mounting bracket.
Step 5 Slide the AP down to sit securely in keyhole slots on the mounting bracket.
Note
Step 6 Using a 10–mm wrench, tighten the four bolts that connect the AP to the bracket to 40 lbf-in (4.5 Nm) of
torque.
Step 7 Proceed with installing antennas (only for external antenna models), connecting the data cables, grounding
the AP, powering and configuring the AP.

Vertically Mounting the AP with DC Supply to a Pole

The AIR-MNT-VERT2= fixed mounting kit contains a mounting bracket for both wall-mounting and
pole-mounting, the AP, along with the power supply kit. This mounting kit supports metal, wood, or fiberglass
poles from 2 to 5 inch (51 to 127 mm) in diameter.
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
46
You can use an exterior-grade plywood backboard to mount the AP to stucco, cement, or drywall.
The mounting wall, attaching screws, and wall anchors must be able to support a 50-lb (22.7–kg)
static weight.
The AP should be mounted with the status LED on the base facing downwards.
Installation Overview
Supplied in the
Kit?
No
No