Cisco Catalyst 9124AX Series Hardware Installation Manual page 10

Cisco Catalyst 9124AX Series Outdoor Access Point Features
• Available in three model SKUs: Omni (-I) antenna (C9124AXI-x), Directional (-D) antenna
(C9124AXD-x), and External (-E) antenna (C9124AXE-x).
• Four dual-band 2.4-GHz and 5-GHz integrated antennas on the C9124AX AP models (C9124AXI-x and
C9124AXD-x).
• Four dual-band 2.4-GHz and 5-GHz, and two 5-GHz antenna ports on the C9124AXE AP model
(C9124AXE-x).
Note
The x in the model numbers represents the regulatory domain. For information about supported regulatory
domains, see
• MU-MIMO technology for uplink and downlink.
• OFDMA-based scheduling for both uplink and downlink.
• Multigigabit Ethernet (mGig)
• The following hardware external interfaces:
• 1x100/1000/2500 Multigigabit Ethernet (PD or PoE-IN)
• 1xSFP port (Uplink)
• 1x1G Ethernet port (PSE or PoE-Out)
• RS-232 Console Interface through RJ-45
• Recovery push button (enables partial or full system configuration recovery)
• One multicolor LED status indicator. For information about the colors of the LED status indicator,
• Integrated Bluetooth Low Energy (BLE) radio enables IoT use cases such as location tracking and
wayfinding.
• Cisco RF ASIC, a fully integrated Software Defined Radio (SDR), can perform advanced radio frequency
(RF) spectrum analysis, and deliver features such as next-generation CleanAir, Wireless Intrusion
Prevention System (WIPS), Dynamic Frequency Selection (DFS) detection.
• Intelligent Capture probes the network and provides Cisco Digital Network Architecture (DNA) Center
with in-depth analysis.
• Spatial Reuse (also known as Basic Service Set [BSS] coloring) allows the AP and their clients to
differentiate between BSS, thus permitting simultaneous transmissions.
• A new power savings mode called Target Wake Time (TWT) allows clients to stay asleep and wake up
only at prescheduled (target) times to exchange data with the AP. This mode provides significant energy
savings for battery-operated devices.
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
2
Note The C9124AX Series AP uses an internal omni BLE antenna.
AP Model Numbers and Regulatory Domains, on page
see Checking the Access Point LEDs, on page
About the Cisco Catalyst 9124AX Series Outdoor Access Point
3.
82.