Connecting A Power Injector - Cisco Catalyst 9124AX Series Hardware Installation Manual

Connecting a Power Injector

SKU
C9124AXE
Tri-Radio
mode
Connecting a Power Injector
The AP supports the following power injectors:
Table 13: Supporting Power Injectors
Power Source
AIR-PWRINJ-60RGD1=
AIR-PWRINJ-60RGD2=
AIR-PWRINJ6=
The power injector provides DC voltage to the AP over the Ethernet cable and supports a total end-to-end
Ethernet cable length of 100 m (328 ft) from the switch to the AP.
When an optional power injector powers your AP, follow these steps to complete the installation:
Procedure
Step 1
Before applying PoE to the AP, ensure that the AP is grounded (see
66).
Step 2 Identify the components needed for the installation, see the
on page
Step 3 Connect a CAT5e or better Ethernet cable from your wired LAN network to the power injector.
Danger
Note
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
68
PoE-in/DC Radio 0 dBm
Input
.3af disabled —
.3at disabled —
.3bt / 2x2 24
UPOE
DC 2x2 24
input
Description
60W rated outdoor power injector, with North America AC plug
60W rated outdoor power injector, global version without AC plug
30W rated single-port PoE injector
32.
To reduce the risk of fire, use only No. 24 AWG or larger telecommunication line cord.
Statement 1023
The installer is responsible for ensuring that powering the AP from this type of power injector is
allowed by local and/or national safety and telecommunications equipment standards.
Radio dBm AUX Ethernet
1 Radio mGig
disabled — enabled 1G
disabled — enabled 1G
2x2 24 enabled 2.5G
2x2 24 enabled 2.5G
Typical Access Point Installation Components,
Installation Overview
SFP GbE PoE-out
Module PHY
N N N
N N N
Y Y 15.4W
Y Y 15.4W
Grounding the Access Point, on page
Notes
Serving
radios
disabled
-
PoE output
is 802.3af
compliant
using DC
power
source
≥60W