Test Oil Connections - Bosch EPS 610 Original Instructions Manual

en 16 | EPS 610 | Initial start-up
10. Rotate the HMI tray such that the second dome nut
is directly above the slot in the front panel.
11. Tighten the other dome nut.
Fig. 14: Tightening the dome nut
1 Plug
2 Stud
3 Spring washer
4 Dome nut
5 Slot for tightening the dome nuts
6 Lever
7 Ratchet
12. Rotate the HMI to a convenient position.
!
Overtightening the screw might damage the spring.
13. Insert the locking screw (Fig. 13, Pos. 4) into the
spring (Fig. 13, Pos. 3). Insert a plain washer
(Fig. 13, Pos. 2) and nylon washer (Fig. 13, Pos. 1)
at the other end of the screw. Insert the whole
assembly into the screw hole of the HMI locking
mechanism. Tighten the screw only till a short
length of the screw shank is engaged inside the
screw hole of the HMI stand.
14. Press one of the keys gently on the HMI to check if
there is no rotation. If there is rotation, tighten the
locking screw till the displacement is arrested.
15. Switch on the mains supply.
16. Switch on the master switch on the EPS 610.
 The HMI boots after a few seconds and the dis-
play starts.
17. Press the <Test oil pump on / off> key and check
the direction of rotation of the test oil motor on the
HMI display. Refer to chapter 5.1.
i
Observe the label pasted on the test oil motor to
find the correct direction of rotation. If the direction
of rotation is incorrect, switch off the master switch
and the mains supply. Interchange any two phases at
the mains and ensure that the motor runs in correct
direction.
|
F 002 DG9 918 2017-10-16
18. Switch off the master switch.
19. Switch off the mains supply.
20. Close the motor RH or LH panel.
21. Close the control cabinet.
1
"
2
3
4.4.4
4
i
1. Open the bottom right panel (Fig. 1, Pos. 11).
2. Check if any hydraulic connections are disconnected.
5
i
6
3. Loosen the fasteners on the tank cover.
7
4. Open the cover.
!
5. Clean the test oil tank thoroughly with a clean soft
6. Fill about 50 lts of
i
i
The HMI connection is complete.

Test oil connections

All the test oil connections of the EPS 610 are con-
nected at the factory and are ready to use.
If there are any connections that have come loose,
restore the connections.
Use only test oil ISO 4113. Do not use inflammatory
liquids such as petrol, naphtha or thinner.
cloth.
ISO 4113
oil tank.
To order ISO 4113 test oil, use the part number
F 002 S3E 001.
During the test run, it is necessary to bleed air pock-
ets in the pipeline and top up the oil level in the test
oil tank.
fresh test oil to the test
Bosch Limited