Installing The Adapter Perc Module - Dell EMC Core XC750 Installation And Service Manual

Installing the adapter PERC module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the expansion card
4. If installing a new APERC module, unpack it and prepare the module for installation.
NOTE: For instructions, see the documentation accompanying the card.
NOTE: APERC module must be installed only in expansion card riser 1 or riser 2.
Steps
1. Pull and lift up the expansion card retention latch lock to open.
2. If installed, remove the filler bracket.
NOTE: Store the filler bracket for future use. Filler brackets must be installed in empty expansion card slots to maintain
Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the
system and aid in proper cooling and airflow inside the system.
Figure 78. Removing the filler bracket
3. Hold the adapter PERC (APERC) module by the edges, and align the module edge connector with the expansion card
connector on the riser.
4. Insert the module firmly into the expansion card connector until seated.
5. Close the expansion card retention latch.
6. Push the card holder to hold the module in the riser.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
76 Installing and removing system components
Safety instructions.
Before working inside your system
risers.