Table of Contents
Advertisement
MAINTENANCE
4) Disconnect gas line to stove.
5) Disconnect 3/8" NPT pipe from 90
6) Disconnect the two (2) switch wires from valve.
7) Remove two (2) orifice bracket screws inside firebox.
8) Remove thermodisc to bracket by removing three (3) phillips head
M5 screws.
9) Remove front cover with Piezo Igniter by removing two (2) sheet
metal screws.
10) Loosen four (4) phillips head M5 valve mounting screws from un-
derside of firebox. Push valve assembly forward on the teardrop
slots and drop down.
11) Disconnect Piezo wire.
Placement
of Decal
"Warning
240 Volts"
1) To install a new valve assembly, reverse instructions for removing valve.
See assembly steps 1-11.
2) Check for leaks and manifold pressure. See Gas Pressure Test instruc-
tions.
3) To reinstall valve, reverse instructions for removing valve assembly, steps
12-18.
18
elbow on valve.
o
Front Cover Screws
Front of Stove
On/Off
Piezo
Ignitor
Gas Inlet
Valve
mounting screws
WARNING
T-O-D 60711
240 Volts
x
L200-40F
Thermodisc
Bracket
Thermodisc
VIEW FROM BOTTOM OF THE STOVE
INSTALLING VALVE ASSEMBLY
To remove valve from valve assembly, continue.
12) Remove two (2) thermopile wires.
13) Remove thermocouple with a 9 mm (metric) spanner.
14) Remove pilot nut with an 11 mm spanner.
15) Remove valve to orifice nut with a 13/16" spanner.
16) Remove inlet pipe with pipe spanner. Note orientation of 90
bow.
17) Remove two (2) phillips head M5 screws on each side of the
valve.
18) Remove valve and remove gas out 90
tion of fitting.
Hi/Lo
313717
9426
Thermocouple
T-O-D
SA
1
3
nut
brass fitting. Note orienta-
o
Thermopile
wires
Orifice
Thermocouple
wire
Gas Outlet
Regency
F33-3 Freestanding Gas Stove
®
el-
o
Orifice assembly
mounting screws
Advertisement
Table of Contents
