Media Calibrat Ion Wizard - Datamax E-Class Mark III Operator's Manual

3 .7 .2 M e dia Ca libr a t ion W iza r d
The Media Calibrat ion Wizard can be perform ed using t he DMXConfig Ut ilit y ( see Sect ion 3.5) . Once you have
inst alled t he DMXConfig ut ilit y and t he print er is properly loaded wit h m edia, proceed wit h calibrat ion as
follows:
1) Connect t he host t o t he print er wit h a serial,
parallel, or ( USB cable if driver is inst alled) .
2) Turn ON t he print er and launch t he
DMXConfig ut ilit y.
3) Click on t he port or t he print er you wish t o
connect t o from t he list .
4) Query t he print er by using t he Query Print er
t oolbar but t on ( t op- left ) or t he large 'Query'
but t on in t he green box. This will connect t o
t he print er and get t he current print er
set t ings.
5) Select t he Sensor Calibrat ion Tab and t hen
click t he Media Calibrat ion Wizard but t on.
When prom pt ed click OK t o st art t he
calibrat ion wizard.
6) The Calibrat ion Wizard will now prom pt you t o
Rem ove St ock. Rem ove m edia and backing
from t he print er. Close t he cover and click
OK.
Ch a pt e r 3 – Pr in t e r Ope r a t ion 2 3