Table of Contents
Advertisement
Useful Information
Problem
I cannot hear a dial tone.
The base unit beeps.
The unit does not work during a
power failure.
Menu list
Problem
The display is in a language I
cannot read.
I cannot activate the eco mode.
I cannot register a handset to a
base unit.
*1 KX-TGF310BX/KX-TGF320BX
Battery recharge
Problem
The handset beeps and/or
flashes.
I fully charged the batteries, but
–
still flashes or
– the operating time seems to
be shorter.
52
KX-TGF310_320BX_UE_0706_ver002.pdf 52
Cause/solution
R Make sure that you are using the supplied telephone line cord.
Your old telephone line cord may have a different wiring
configuration.
R The base unit's AC adaptor or telephone line cord is not
connected. Check the connections.
R Disconnect the base unit from the telephone line and connect the
line to a known working telephone. If the working telephone
operates properly, contact our service personnel to have the unit
repaired. If the working telephone does not operate properly,
contact your phone service provider.
R New messages have been recorded. Listen to the new messages
(page 42).
R You can insert 2 AAA (R03) batteries (not supplied) into the base
unit that will power the unit temporarily in the event of a power
failure (page 9).
R The base unit display is blank if the saving mode is "On"
(page 10).
Cause/solution
R Change the display language (page 14).
R You cannot set eco mode when you set the repeater mode "On".
If required, set the repeater mode to "Off" (page 38).
R The maximum number of handsets (6) is already registered to the
base unit. Cancel unused handset registrations from the base unit
*1
(page 37).
R You entered the wrong PIN. If you forget your PIN, contact an
authorised service centre.
Cause/solution
R Battery charge is low. Fully charge the batteries (page 9).
R Clean the battery ends (
dry cloth and charge again.
R It is time to replace the batteries (page 8).
,
) and the charge contacts with a
7/29/2015 11:36:02 AM
Advertisement
Table of Contents
