Table of Contents
Advertisement
Figure 53. Installing the intrusion switch
2. Connect the intrusion switch cable to the connector on the system board.
Next steps
Follow the procedure listed in
System board
This is a service technician replaceable part only.
Removing the system board
Prerequisites
CAUTION:
If you are using the Trusted Platform Module (TPM) with an encryption key, you may be prompted
to create a recovery key during program or System Setup. Be sure to create and safely store this recovery key.
If you replace this system board, you must supply the recovery key when you restart your system or program
before you can access the encrypted data on your drives.
NOTE:
Do not attempt to remove the TPM plug-in module from the system board. After the TPM plug-in module is
installed, it is cryptographically bound to that specific system board. Any attempt to remove an installed TPM plug-in
module breaks the cryptographic binding, and it cannot be reinstalled or installed on another system board.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the following components:
a.
Expansion card
b.
Internal USB key
c.
Heat sink module
d.
Processor
e.
Memory module
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
61
Advertisement
Table of Contents
