f. Enter the System Setup and if the time and date are still incorrect, see
Intrusion switch
This is a service technician replaceable part only.
Removing the intrusion switch
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Steps
1. Disconnect the intrusion switch cable from the connector on the system board.
2. Slide and push the intrusion switch out of the intrusion switch slot on the system.
Figure 52. Removing the intrusion switch
Next steps
Replace the intrusion
switch.
Installing the intrusion switch
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Steps
1. Align the intrusion switch to the intrusion switch slot and slide the intrusion switch to lock in place.
60
Installing and removing system components
Safety
instructions.
Before working inside your
Safety
instructions.
Before working inside your
Getting help
system.
system.
section.