Change Filter Timer Program; Secondary Filtration Program - Jacuzzi LED Series Troubleshooting Manual

ting should not be altered. Running the circulation pump less than the factory recommended time will
result in issues with water quality maintenance.
Note: The 24-hour primary filtration system also supplies heated water to the spa when the heater
turns on.

5.3 Change Filter Timer Program

• Follow the steps below to access the Change Filter Timer.
Menu button Action
Press once
Press
or
continually
Press once
Press con-
or
tinually
Press once
When time
expires

5.4 Secondary Filtration Program

The jets pump 1 activates during the secondary filtration to provide additional skimming. The spa is
programmed with a default setting of SF0 but can be programmed to any of the cycle settings listed
below, Figure 5. These cycles schedule the jets pump 1 to run for a preset amount of time per day, in
addition to normal operation.
Note: During the secondary filtration the jets pump 1, circulation pump and CLEARRAY are activated.
• Follow the steps below to access the program.
Menu button Action
Press twice
Press once
Press
or
continually
Press once
To access the Primary Filtration Menu. The LED will display "PF."
Scrolls through the menus as follows:
, , ,
To access the Change Filter Timer. The display on the LED screen will
blink once to indicate that the system is ready to accept changes.
To add or subtract days in increments of 10 days. Range is from 0 to 180
days.
Once the number of days is selected, to confirm your selection.
The LED screen will flash between 0 and
To access the Secondary Filtration Menu. The LED will display "SF."
Activates the system for changes. Last programmed cycle blinks once
on the display.
Scrolls through the menus as follows:
The new programmed cycle will blink twice on the display to confirm
your selection.
10 minutes of filtration every 12 hrs
10 minutes of filtration every 8 hrs
10 minutes of filtration every 6 hrs
Result
,
Result
No filtration
, , ,
, ,
, ,
or
9