TYAN Thunder n6550EX Manual page 93

4.7.2 IDE Configuration Sub-Menu
You can use this screen to select options for the IDE Configuration
Settings. Use the up and down <Arrow> Keys to select an item. Use
the <Plus> and <Minus> Keys to change the value of the selection
options.
Main Advanced
IDE Configuration
Onboard IDE Controller
Serial-ATA Devices
NVIDIA RAID Setup
Primary IDE Master
Primary IDE Slave
SATA0 (Dev5, Func0)
SATA1 (Dev5, Func0)
SATA2 (Dev5, Func1)
SATA3 (Dev5, Func1)
SATA4 (Dev5, Func2)
SATA5 (Dev5, Func2)
Hard Disk Write Protect
IDE Detect Time Out (Sec)
ATA (PI) 80Pin Cable
Detection
Feature
IDE Configuration
Onboard IDE
Controller
Serial-ATA
Devices
Hard Disk Write
Protect
IDE Detect Time
Out (Sec)
ATA (PI) 80Pin
Cable Detection
BIOS Setup Utility
PCI/PnP Boot
[Enabled]
[Device 0/1/2]
[Not Detected]
[Not Detected]
[Not Detected]
[Not Detected]
[Not Detected]
[Not Detected]
[Not Detected]
[Not Detected]
[Disabled]
[35]
[Host & Device]
Option
Enabled
Enable/Disable onboard IDE controller.
Disabled
Device 0/1/2
Disabled
Configure serial ATA devices.
Device 0
Device 0/1
Enable/Disable device write protection.
Disabled
This will be effective only if device is
Enabled
accessed through BIOS.
0~35 Select the time out value for detecting
(at 5 interval) ATA/ATAPI device(s).
Host & Device
Select the mechanism for detecting 80Pin
Host
ATA(PI) cable.
Device
87
http://www.tyan.com
Security Chipset
While entering setup, BIOS
auto detects the presence
of IDE devices. This
displays the status of auto
detection of IDE devices.
← → Select Screen
↑↓ Select Item
+/- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
Description
Exit