TYAN Thunder n6550EX Manual page 107

4.7.8 Remote Access Configuration Sub-Menu
You can use this screen to view the Remote Access Configuration
Menu. This feature allows access to the Server remotely via serial
port. Use the up and down arrow ( / ) keys to select an item. Use
the Plus and Minus (+/-) keys to change the value of the selected
option. The settings are described on the following pages.
Main Advanced
Configure Remote Access type and parameters
Remote Access
Serial Port Number
Base Address, IRQ
Serial Port Mode
Flow Control
Redirection After BIOS POST
Terminal Type
VT-UTF8 Combo Key Support
Serdir Memory Display Delay
Feature
Configure Remote Access type and parameters
Remote Access
Serial Port Number
Serial Port Mode
Flow Control
Redirection After BIOS
POST
Terminal Type
VT-UTF8 Combo Key
Support
Serdir Memory Display
Delay
BIOS Setup Utility
PCI/PnP Boot
[Disabled]
[COM1]
[3F8h,4]
[115200 8,n,1]
[None]
[Always]
[ANSI]
[Enabled]
[NO Delay]
Option
Enabled
Disabled
COM1
115200 8, n,1
56700 8,n,1
38400 8,n,1
19200 8,n,1
09600 8,n,1
None
Hardware
Software
Disabled
Always
ANSI
VT100
VT-UTF8
Enabled
Disable
No Delay
Delay 1Sec
Delay 2Sec
Delay 4Sec
101
http://www.tyan.com
Security Chipset
Select remote
access type.
← → Select Screen
↑↓ Select Item
+/- Change Field
F1 General Help
F10 Save and Exit
ESC Exit
Description
Enables remote access to
system through serial port.
Select Serial Port for console
redirection.
Select Serial Port Settings..
Select Flow Control for console
redirection.
Disabled: turns of the
redirection after Boot.
Redirection is active during
POST and during Boot loader.
Select the target terminal type.
Enable/Disable VT-UTF8
combination key support for
ANSI/VT100 terminals.
Gives the delay in seconds to
display memory information.
Exit