Table of Contents
Advertisement
3.4.1.3 Configure Network Interface via Serial port
You need prepare another computer; connect a null modem cable between this
computer and TYAN
Open the serial console software on your computer (The serial console software
can be hyper terminal (Windows) or Kermit (Linux)), configure the serial port
with following setting:
Parameter
Baud Rate
Data bits
Parity
Stop bits
Flow Control
Remove the host system power first. Connect power supply cable, and then
press ESC key on remote computer immediately. If successfully, you will see
"=>" prompt on serial console:
®
motherboard (host system) back panel serial port.
http://www.tyan.com
Value
115200
8
No
1
none
34
Advertisement
Table of Contents
