Advertisement
Step 4
BH17
The door jambs reinforce the door
opening and provide an attractive
trim. The studs provide a surface for
attaching the siding panels.
1
Fasten the top of the door jambs
to the door track with 2 screws. Do
the same for the bottom into frame.
Notched edge faces toward center
of building. Fasten middle hole on
inside edge of door jamb with a bolt
inside building and a hex nut with an
acorn nut outside, as shown.
2
Place a stud between each corner
post at the sides of building and 2
studs between corner posts at the
rear. Position stud inside top angle
and fasten with a screw at the lower
hole.
3
Rest bottom tab (large hole) out-
side oor frame. Do not fasten tab at
this time. Repeat procedure for the
remaining studs around the building.
Parts Needed For
Door Jambs/Studs
NOTCHED EDGE
MUST FACE CENTER OF
Bolt
3/8" (10 mm)
Hex Nut
Acorn Nut
7311
Washer
STEP
1
7311
9344
17
BUILDING
STEP
2
9344
9344
LARGE HOLE
7311 Door Jamb (2)
9344 Siding Stud (4)
FASTEN STUD AT
LOWER HOLE
9344
STEP
3
DO NOT FASTEN TAB
AT THIS TIME
Advertisement
