Troubleshooting - AEG CIS6742ECM User Manual

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem
You cannot activate the ap‐
pliance.
You cannot activate the ap‐
pliance.
You cannot activate or oper‐
ate the hob.
You cannot activate or oper‐
ate the hob.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
Residual heat indicator does
not come on.
Automatic Heat Up function
does not operate.
Automatic Heat Up function
does not operate.
The sensor fields become
hot.
There is no signal when you
touch the panel sensor
fields.
comes on the hob dis‐
play.
Possible cause
The appliance is not connec‐
ted to an electrical supply or
it is connected incorrectly.
The fuse is blown.
You touched 2 or more sen‐
sor fields at the same time.
There is water or fat stains
on the control panel.
You put something on one or
more sensor fields.
The zone is not hot because
it operated only for a short
time.
The zone is hot.
The highest heat setting is
set.
The cookware is too large or
you put it too near to the
controls.
The signals are deactivated.
Automatic Switch Off oper‐
ates.
ENGLISH
Remedy
Check if the appliance is cor‐
rectly connected to the elec‐
trical supply.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali‐
fied electrician.
Touch only one sensor field.
Clean the control panel.
Remove the object from the
sensor fields.
If the zone operated suffi‐
ciently long to be hot, speak
to an Authorised Service
Centre.
Let the zone become suffi‐
ciently cool.
The highest heat setting has
the same power as the func‐
tion.
Put large cookware on the
rear zones if possible.
Activate the signals. Refer to
"Hob - Daily use" chapter.
Deactivate the hob and acti‐
vate it again.
35