Table of Contents
Advertisement
To replace the glass panels, do the same
steps in reverse. Before you lower the
trim, attach the A trim part to the door.
Refer to the image.
12.8 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the oven. Wait until the oven is
cold.
2. Disconnect the oven from the mains.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem
You cannot activate the appliance.
You cannot activate the appliance.
The burners do not work.
There is no spark when you try to
activate the spark generator.
The flame extinguishes immediately
after ignition.
The flame ring is uneven.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
3. Put a cloth on the bottom of the cavity.
The back lamp
The lamp glass cover is at the back of
the cavity.
1. Turn the lamp glass cover
2. Clean the glass cover.
3. Replace the oven lamp with a suitable
4. Install the glass cover.
Possible cause
The appliance is not connected to
an electrical supply or it is connec‐
ted incorrectly.
The fuse is blown.
There is no gas supply.
Burner cap and crown are placed in‐
correctly.
Thermocouple is not heated up suf‐
ficiently.
Burner crown is blocked with food
residues.
The oven is deactivated.
The clock is not set.
The necessary settings are not set.
counterclockwise to remove it.
300 °C heat-resistant oven lamp.
Use the same oven lamp type.
Remedy
Check if the appliance is correctly
connected to the electrical supply.
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
Check the gas connection.
Place the burner cap and crown cor‐
rectly.
After lightning the flame, keep the
knob pushed for equal or less than
10 seconds.
Make sure that the injector is not
blocked and the burner crown is
clean.
Activate the oven.
Set the clock.
Make sure that the settings are cor‐
rect.
ENGLISH
27
Advertisement
Table of Contents
