9. Align the pin 1 indicator of processor carrier clip with one of the diagonally cut corners on the base of the
heat sink. Or (if present) look for the Pin #1 indicator on the corner of the heat sink label.
10. Gently press down the heat sink onto the processor carrier clip until it clicks into place.
11. Ensure all four heat sink corners are securely latched to the processor carrier clip tabs.
2.3.2.2
EVAC PHM Installation
1. Remove the riser assembly on the right side of the module.
•
Remove the three screws that secure the riser assembly to the module (see Letter A).
•
Carefully remove the riser assembly by lifting it up away from the module (see Letter B).
38
Intel® Server D50TNP Family Integration and Service Guide
Figure 25. Pin 1 Indicator of Processor Carrier Clip
Figure 26. Removing a Riser Assembly