Tools - Husqvarna DM 330 Workshop Manual

16
The tools listed below are available from Husqvarna.
22
●
531 12 31-22
Clamping ring
Adjustment of gear box's slip
●
clutch. 1/2 inch wrench attachment.
Used together with adapter
522 91 40-01.
522 91 40-01
Adapter
Used together with clamping ring
531 12 31-22.
525 30 02-01
Mounting sleeve
Fitting the rotor in gear box
●
cover.
● Fitting the rotor wearing ring to
the radial seal.
Workshop wrench, Hex
Universal use.
●
502 50 19-01 3 mm
502 50 18-01 4 mm
502 50 64-01 5 mm
504 90 00-01 6 mm
502 71 27-02
Workshop wrench, Torx T27
● Universal use.
504 90 00-06
Workshop set,
mm-dimensions
Universal use.
●
Hex: 3, 4, 5 and 6 mm
Socket: 8 mm
504 90 90-02
Universalavdragare
● Demontering av spindelaxeln.
● Demontering av spindelaxelns
nedre lager.
531 00 48-67
Bearing puller
Dismantling of rotor wearing
●
ring to the radial seal.

TOOLS

= Service operation
The special tools below are needed for service work to
DM330/DM340 but are not sold by Husqvarna.
Lock ring pliers
Make: Milbar/Imperial IR-15R.
Plier for small external lock
rings without pickup holes.
● Dismantling and fitting of the
intermediate shaft's lock ring.
Dismantling and fitting of the
●
gear knob.
Counter stay device
There are a number of manu -
facturers, e.g.: Kukko (Germany),
Snap-On (USA).
● Dismantling of ball bearings
and needle bearings in gear
housing and gear box cover.
Removal of seal rings (radial
●
seals).
Multimeter
Make: Amprobe 37XR-A.
One of few universal instru-
ments that can also measure
inductance (H, Henry).
● Check of electric motor's
functions.