Gear Housing - Intermediate Shaft - Husqvarna DM 330 Workshop Manual

7 GEAR HOUSING – INTERMEDIATE SHAFT
10
Dismantling –
intermediate shaft
Gear selection position 2
Set the gear selector to position 2.
Remove the circlip and lift up the
gear drive
Remove the circlip on the spindle shaft
using circlip pliers. Lift out the gear
drive.
Remove the wedge
Remove the wedge on the spindle shaft.
Remove the intermediate shaft
Use a standard puller and place the claws
under the first gear wheel.
Create a counterhold by placing a cold
chisel, for example, on the gear housing.
Press the shaft up using the puller.
Remove the circlip
Remove the circlip using circlip pliers.
Lift out the gear wheel
Lift off the gear drive