Husqvarna DM 330 Workshop Manual page 11

GEAR HOUSING – INTERMEDIATE SHAFT
Remove the guide wedge
Remove the lock ring
A small pair of lock ring pliers is needed
to remove the lock ring, manufacture:
Milbar/Imperial IR-15R) or equivalent
Start by turning the lock ring to ensure
Milbar/Imperial
the opening is accessible by pliers in the
IR-15R
gear wheel. Expand the lock ring using
the pliers and lift the ring up.
Lift off gear wheel
Gear knob
Dismantling
Drive out the locking pin using a pin
punch and remove the knob.
Remove the lock ring using a small pair
of locking ring pliers, Milbar/Imperial
IR-15R) or equivalent. Press the gear
selector into the gear housing.
Fitting
Note the position of the knob in relation
to the gear selector when reassembling.
7
11