Wiring Diagram, Cabling - 120 V - Husqvarna DM 330 Workshop Manual

BLACK
BLACK
BLACK
BLACK
Residual Current Device
1
a
3
c
5
a
c
WIRING DIAGRAM, CABLING – 120 V
YELLOW
BLACK
RED
GREY
BLACK
BROWN
BLUE
GREEN/YELLOW
2
b
4
6
b
Assembly diagram
The assembly diagram shows the colours
and positions of the connection cables
Stator
for the electrical connections.
GREY
Rotor
Stator
Component placement
Figure 1
The figure shows the position of the
cables in the motor housing when the
cover is removed.
screw to the gear box cover.
b
circuit breaker at the circuit board.
Figure 2
The cable (b) from the stator must be
attached to the upper bracket. The cables
to the speed sensor are to lie under the
stator cable.
Figure 3
The figure shows how the cables are
attached to the circuit board. The stator
cable (b) and the short connection (c)
between the circuit board and carbon
brush on the right-hand side, seen from
behind.
Figure 4
Note how the cables (a) are to lie in the
slot.
Figure 5
The figure shows the cable routing in the
motor housing and the connections to
d
the circuit board. View from the left side
seen from behind.
Figure 6
Detail from figure 5.
Note that both the stator cables (d) are
connected to this carbon brush holder.
d
Note the earth cable is attached with a
The two black cables (a) lead to the
12
17