Opel MOKKA Manual page 56

If you say "Phone", the system understands
that a phone call is requested and responds
with respective questions until enough
details are gathered. If the phone number has
been saved with a name and a place, the
direct command should include both, for
." example "Call David Smith at work
Selecting list items
When a list is displayed, a voice prompt asks
to confirm or select an item from that list. A
list item may be manually selected, or by
. speaking the line number of the item
The list on a speech recognition screen
functions the same as a list on other screens.
Manually scrolling the list on a screen
during a speech recognition session
suspends the current speech recognition
event and plays a prompt like "Make your
selection from the list using the manual
controls, or press BACK on the faceplate to
If no manual selection is made within
15 seconds, the speech recognition session
terminates, you are prompted with a
message, and the former screen is
The voice prompt can be interrupted by
pressing w again. If you wish to
directly speak your command, press
Wait for the beep and then speak the
command naturally. In most cases,
recognition rates will be higher if
pauses are kept to a minimum. Use
. short and direct commands
Usually phone and audio commands can be
spoken in a single command. For example,
"Call David Smith at work", "Play"
followed by the artist or song name, or
"Tune to" followed by the radio frequency
Navigation destinations, however, are too
complex for a single command. First, state
"Navigation" and then, e.g. "Address" or
"Point of Interest". The system responds
." try again
After saying "Point of Interest", only major
chains may be selected by name. Chains are
businesses with at least 20 locations. For
other POIs, say the name of a category, e.g.
"Restaurants", "Shopping centres", or
. redisplayed
Direct commands are easier understood by
." the system, e.g. "Call 01234567
●
. w twice
●
. and the waveband
. with requesting more details
." "Hospitals
Speech recognition
In the following situations, a dialogue
: sequence is automatically cancelled
If you do not say any commands for
some time (by default you are
prompted three times to say a
.( command
If you say commands that are not
recognised by the system (by default
you are prompted three times to say a
.( correct command
Operation via speech commands
The speech recognition can understand
commands that are either naturally stated in
sentence form, or direct commands stating
. the application and the task
: For best results
Listen for the voice prompt and wait
for the beep before saying a command
. or replying
Say "Help" if you want to listen again
to the help prompt for the current
. dialogue step
٥٦
●
●
●
●