Ipv6 Interface Setup - ZyXEL Communications XS3800-28 User Manual

The following table describes the labels in this screen.
Table 39 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Global Setup
LABEL
IPv6 Hop Limit
ICMPv6 Rate
Limit Bucket
Size
ICMPv6 Rate
Limit Error
Interval
Apply
Cancel
Clear

8.9.5 IPv6 Interface Setup

Use this screen to turn on or off an IPv6 interface. Click the link next to IPv6 Interface Setup in the IPv6
Configuration screen to display the screen as shown next.
Figure 91 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Interface Setup
The following table describes the labels in this screen.
Table 40 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Interface Setup
LABEL
Interface
Active
Apply
Cancel
Clear
Index
Interface
Active
Chapter 8 Basic Setting
DESCRIPTION
Specify the maximum number of hops (from 1 to 255) in router advertisements. This is the
maximum number of hops on which an IPv6 packet is allowed to transmit before it is discarded by
an IPv6 router, which is similar to the TTL field in IPv4.
Specify the maximum number of ICMPv6 error messages (from 1 to 200) which are allowed to
transmit in a given time interval. If the bucket is full, subsequent error messages are suppressed.
Specify the time period (from 0 to 2147483647 milliseconds) during which ICMPv6 error messages
of up to the bucket size can be transmitted. 0 means no limit.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Clear to reset the fields to the factory defaults.
DESCRIPTION
Select the IPv6 interface you want to configure.
Select this option to enable the interface.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Clear to reset the fields to the factory defaults.
This is the interface index number. Click on an index number to change the settings.
This is the name of the IPv6 interface you created.
This field displays whether the IPv6 interface is activated or not.
XS3800-28 User's Guide
127