Set Supervisor/User Password - MSI MS-6341 Manual

Hide thumbs Also See for MS-6341:

Table of Contents

Set Supervisor/User Password

When you select this function, a message as below will appear on the screen:

8Standard CMOS Features

8Advanced BIOS Features

8Advanced Chipset Features

8Integrated Peripherals

8Power Management Setup

8PnP/PCI Configurations

8PC Health Status

Esc: Quit

F10: Save & Exit Setup

Type the password, up to eight characters in length, and press <Enter>. The

password typed now will clear any previously entered password from CMOS

memory. You will be asked to confirm the password. Type the password again

and press <Enter>. You may also press <Esc> to abort the selection and not

enter a password.

To disable a password, just press <Enter> when you are prompted to enter the

password. A message will confirm the password will be disabled. Once the

password is disabled, the system will boot and you can enter Setup freely.

When a password has been enabled, you will be prompted to enter it every

time you try to enter Setup. This prevents an unauthorized person from chang-

ing any part of your system configuration.

Enter Password:

Time, Date, Hard Disk Type…

8Frequency/Voltage Control

Load Fail-Safe Defaults

Load Optimized Defaults

Set Supervisor Password

Set User Password

Save & Exit Setup

Exit Without Saving

↑ ↓ → ←

3-29

AWORD

BIOS Setup

Table of Contents

Table of Contents