Table of Contents
Advertisement
Chapter 3
Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC+Blank
Blank Screen
DPMS Support (default) Initial display power management
Standby Mode
This allows you to set the time period before the system goes into standby
mode. Setting options: [30sec] [Disabled] [1/4/10/20/30 min] [1 hour]. Default
value:[Disabled]
HDD Power Down
This allows you to set the time period before the hard disk drive will be
powered down while all other devices remain active. Setting options: [Disabled]
[1/2/3/4/5/6/7 min]. Default value: [Disabled]
HDD Down In Suspend
When enabled, the hard disk drive will be powered down while the other de-
vices are in suspend mode. Setting options: [Disabled] [Enabled]. Default
value: [Disabled]
Soft-off by PBTN
Choose the value of [Delay 4 Sec] to allow pressing the power button for more
than 4 seconds to force the system to enter the Soft-Off state. Setting options:
[Delay 4 sec] [Instant-Off]. Default value: [Instant-Off]
This selection will cause the system to
turn off the vertical and horizontal
synchronization ports and write blanks to
the video buffer.
This option only writes blanks to the video
buffer.
signaling.
3-20
Advertisement
Chapters
Table of Contents
