Daikin 4MXS-R Series Service Manual page 260

Field Settings
Wireless Remote
Factory set is 1. Change the wireless remote controller address setting by the following steps, if
necessary.
Controller
1. Hold down
Address
2. Press
3. Press
4. Press RESERVE button to confirm the setting.
5. Hold down
Multiple Settings
When the indoor unit is controlled by an outside controller (central remote controller, etc.), the
indoor unit sometimes does not respond to ON/OFF command or temperature setting command
or
from the wireless remote controller. Check what setting the customer needs and make the multiple
setting as shown below.
Multiple settings
: Standard
: Multi System
247
button and
field setting mode. (SETTING is indicated on the display).
FAN button and select display setting ( or ). Each time the button is pressed, the
display switches between
button and button to set the address.
Address can be set from 1 ~ 6, but set it to 1 ~ 3 and to same address as the transmitter board.
(The transmitter board does not work with address 4 ~ 6.)
/TEST button to quit the field setting mode and return to the normal display.
Field setting mode
Address
Multiple setting
Remote controller
Remote controller
display
All items displayed.
Operations remain
displayed shortly after
execution
/TEST button at the same time for at least 4 seconds to enter the
and .
To control other air
conditions and units
Commands other than
ON/OFF and
temperature setting
accepted.
(1 LONG BEEP or 3
SHORT BEEPS emitted)
All commands accepted.
(2 SHORT BEEPS)
SiUS121736EA
(R14401)
Indoor unit
For other than on left
All commands accepted.
(2 SHORT BEEPS)
Trial Operation and Field Settings