Software/Firmware Updates - Lincoln Electric FineLine 12864 Operator's Manual

FineLine 300HD Plasma System

6.5 Software/Firmware Updates

6.5.1 Power Supply Firmware
With the System powered, unzip
the update installer onto the
HMI's local drive and then open
the unzipped folder.
Run 'SystemUpdate.exe'
Select 'Connect through
Ethernet.'
Select 'I do not know the IP
address of the welder.'
Select the IP address of the
desired Power Supply from the
list.
Click the Connect button.
Click 'Begin Update.'
Wait for the update to complete.
Click 'OK', and then click
'Finished.'
Use the Plasma Console App to
verify the installed version;
(Diagnostics > Versions Tab).
End of procedure.
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
3
4
Page 82 of 118
BK8053-000107 Rev A.01
5
7
6