Preparations For Playback - Sony DNW-A25 Operation Manual

Playback
4-3 Playback
This section describes playback of
tapes.
Note
When two DNW-A25/A25P units are
combined, set both REMOTE/LOCAL
switches to LOCAL.
For playback using the jog/shuttle
dials, see 3-2 "Finding Edit Points
–Search".
4-3-1 Preparations for
Playback
Perform the following procedure.
1
Connect video/audio signal output
connectors to external equipment
if necessary.
2
Select output audio signals (see
page 2-25).
3
Press the CTL/TC/U-BIT button
to select the time data.
When using CTL
Press the RESET button to set the
value to "0:00:00:00".
When using timecode or user
bits
Select the type of timecode
(VITC/LTC/AUTO) using the sub
LCD menu (see page 2-20).
4
Set the METER switch to CH-1/2
or CH-3/4 to select the channels
indicated by audio level meter.
4-4
Recording and Playback
5
Select the playback format on the
player unit.
To play back cassettes recorded
in Betacam SP format
Set the
SP TAPE switch to SP PB ONLY.
To play back Betacam SP
cassettes recorded in Betacam
SX format
Set the SP TAPE switch to SX.
To output the timecode
synchronized with the output
video signal
The playback timecode or the
timecode read by the timecode reader
can be output from the TC OUT
connector.
Select REGEN in setup menu item
606 (see page 6-22), set the INT/EXT
switch on the control panel to INT,
and the PRESET/REGEN switch to
REGEN.