Table of Contents
Advertisement
1 Channel condition/input video
level display
Depending on the unit's operating
status, one of the following is
displayed here.
COND: Displayed during playback.
The playback condition is
displayed on a scale of three
levels.
CONFI: Displayed during crash
recording when the CONFI is set
to ON in video settings page 1/2
(see page 2-28). The playback
condition of recorded signals is
displayed on a scale of three
levels.
VIDEO: Displayed in E-E mode.
When using composite video, the
video level is displayed on a scale
of nine levels.
PRE-R: Displayed when PREREAD
on video setting page 1/2 is set to
ON. During playback, the
playback condition is displayed
on a scale of three levels. When
using composite video in E-E
mode, the video level is displayed
on a scale of nine levels.
2 Time data display
Displays the time data and its type.
TC: Timecode
UB: User bits
No display: CTL
3 VITC/LTC display
Depending on the unit's operating
status, one of the following is
displayed here.
During playback: VITC when VITC
timecode has been read, LTC
when LTC has been read.
During recording: The timecode
being recorded.
During E-E: The timecode to be
recorded, when it has been read.
4 525/625 display
Displays 525 when the unit is being
used as with the 525 system, and 625
when it is being used with the 625
system.
5 Cassette type and remaining
tape time display
Displays the type of cassette in use
and its remaining time (in 2-minute
increments).
SX: Betacam SX
SP: Betacam SP
OX: Oxide tape
– –: No cassette is loaded.
When the remaining time falls to 2
minutes or less, the indication
becomes 0 and flashes together with
the cassette type indication.
Note
When the unit is playing back a
Betacam SP cassette, the recording/
playback format is displayed
according to the setting of the SP
TAPE switch on the control panel.
6 Remaining battery power
display
Displays the remaining battery power
on a scale of seven levels. When the
power is nearly exhausted, the BATT
display flashes. When the power is
completely exhausted, a flashing E
(End) appears.
7 Audio settings page display
To select one of the groups of the
audio settings pages (AU-1 to AU-4)
or MIX/SWP, press operation button
F1 to highlight this display, then press
the UP or DOWN button. The selected
page in the group or the audio settings
sub page appears when you press the
PAGE button.
2-19
Preparations
Advertisement
Table of Contents
