Connection - Sony DNW-A25 Operation Manual

To DC output
connector
To DC IN
connector
DC cable (supplied with the AC-DN2A)

2-2 Connection

The figure below shows how to
connect two DNW-A25/A25P units
for editing.
Recorder unit
REF. VIDEO 75Ω termination
switch: ON
REF. VIDEO IN
a) 9-pin remote control cable (not supplied)
b) 75 Ω coaxial cable with BNC plugs (not supplied)
c) To input a reference video signal, connect a 75 Ω coaxial cable with BNC plugs (not
supplied) and set the REF. VIDEO 75Ω termination switches as shown in the figure.
Reference video signal
a)
REMOTE
SDI IN
REF. VIDEO IN
c)
Push cables a) and b) in the cable clamps.
4
Supply the AC-DN2A with AC
power.
For procedure on AC power
supply to the AC-DN2A, refer to
the manual for the AC-DN2(A).
REF. VIDEO 75Ω termination
c)
switch: OFF
SDI OUT 1
b)
Player unit
REMOTE
2-5
Preparations