Table of Contents
Advertisement
Sub LCD Menu
For details, see the next section, "To
switch between menu pages".
8 VITC/LTC/AUTO display
To select the type of timecode to use,
press operation button F2 to highlight
this display, then press the UP or
DOWN button. If you select AUTO,
the type of timecode is distinguished
automatically during playback (VITC
if the playback speed is within ±
and set to LTC during recording.
You can switch to the general settings
page by pressing the PAGE button
after pressing operation button F2 to
highlight this display.
For details, see the next section, "To
switch between menu pages".
9 VITC ON/OFF display
Set to ON to record VITC timecode.
You can toggle the display between
ON and OFF by pressing operation
button F3 to highlight this display and
then pressing the UP or DOWN
button.
You can switch to the general settings
page by pressing the PAGE button
after pressing operation button F3 to
highlight this display.
For details, see the next section, "To
switch between menu pages".
0 Source video signal display
You can select CMPST (composite) or
SDI as the source video signal by
pressing operation button F4 to
highlight this display and then
pressing the UP or DOWN button.
CMPST: Composite signal
SDI: SDI signal
2-20
Preparations
If you press the PAGE button after
highlighting this display, the video
settings page appears, allowing you to
make advanced settings.
For details, see the next section, "To
switch between menu pages".
When you set SG on video setting
page 2/2 to one of AUDIO, VIDEO,
1
/
)
and BOTH (see page
2
2-29), "SG" appears in this position.
If you press the UP or DOWN button
with the SG indication highlighted,
you can select one of the following:
CMPST, SDI, and the option selected
for "SG" on video setting page 2/2
(AUDIO, VIDEO, or BOTH).
2-6-2 Sub LCD Menu
Basic Operations
To switch between menu
pages
In addition to the home page, the sub
LCD menu has pages that allow you to
make settings for input and output of
video and audio signals, and other
general settings.
You can switch between pages by
pressing the buttons shown in the
figure below.
For more information about the video
and audio settings pages, see section
2-7 "Input and Output Settings for
Video and Audio Signals (Sub LCD
Menu)".
Advertisement
Table of Contents
