Large Temperature Display; Auto Fresh; Spot Swing; Economy (Cooling Only) - Rinnai J Series Operation Manual

The "SET" temperature display is the default display for the remote control and will be reset when
the controller is turned off and on.
When the room temperature mode is selected any changes to the set temperature will flash
NOTE
on the display for 5 seconds, after which the display will revert to displaying the current room
temperature.

LARGE TEMPERATURE DISPLAY

The set and current room temperatures can be displayed via a large digital display
that is built into appliance and illuminates through the front cover of the indoor unit.
To turn the display on
1. Press the "ON/OFF" button to turn on appliance.
2. Press the "DISPLAY" button, to activate the large digital temperature display.
3. Press the "DISPLAY" button again, to deactivate the large digital temperature
display.
The large temperature display will display the same temperature setting as that currently in use
by remote control.
When the room temperature mode is selected any changes to the set temperature will flash
NOTE
on the display for 5 seconds, after which the display will revert to displaying the current room
temperature.

AUTO FRESH

Cooling and dehumidifying operations, can generate moisture inside the appliance.
Using the "FRESH" function removes such moisture by allowing the fan to run for 3
minutes after every shut-down, avoiding odours and keeping the unit fresh.
1. With the appliance "OFF" press the "FRESH" button, "Anti-F" is shown on the
LCD screen.
2. Pressing the "FRESH" button again will cancel the mode, "FRESH" will no
longer be shown on the LCD screen.
This function will not operate in TIMER OFF or SLEEP modes.
NOTE

SPOT SWING

Press the "SWING ↕ " button.
1.
2. There are 5 pre-set fixed air flow directions available, pressing the "SPOT
SWING" button will allow you to cycle through each of these fixed directions.
3. To select a different fixed direction or to return to continuous circulation press
the "SPOT SWING" button until the desired fixed direction is achieved or until
the swing icon is again displayed.
DO NOT attempt to adjust the air deflector louvre manually as this
can result in damage to the louvre movement mechanisms.
CAUTION

ECONOMY (COOLING ONLY)

In this mode the appliance automatically sets the operation to achieve the most
economical cooling of the room.
Rinnai 13
ADVANCED OPERATION
COOL
SWING LRSWING
POWERCON
iFEEL
Anti-F
H
ON OFF
SWING LRSWING SWING
POWERCON POWERCON
iFEEL iFEEL
H H
ON OFF ON
SWING LRSWING
SWING
POWERCON
POWERCON
iFEEL
iFEEL
H
H
ON OFF
ON
SWING LRSWING SWING
POWERCON POWERCON
iFEEL iFEEL
H H
ON OFF ON
RUN
C
COOL
SPEED
SWING LRSWING
POWERCON
iFEEL
H
ECO ON OFF
Split AC OM
LRSWING
OFF
LRSWING
OFF
LRSWING
OFF