Installation Instructions
Preparation
NOTE:
All the illustrations in the manual are for explanation purpose only. Your machine may be slightly different.
The actual shape shall prevail. The unit can be controlled by the unit control panel alone or with the remote
controller.
front
Design Notice
In order to ensure the optimal performance of our products, the design specifications of the unit
and remote control are subject to change without prior notice.
Energy Rating Information
The Energy Rating for this unit is based on an installation using an un-extended exhaust duct without
window slider adaptor (as shown in the Installation section of this manual).At the same time, the unit
must be operating on the COOL MODE and HIGH FAN SPEED by remote controller.
Ambient Temperature Range For Unit Operating
MODE
Temperature Range
Cool
17-35°C (62-95°F)
Dry
13-35°C (55-95°F)
Exhaust hose installation
The exhaust hose and adaptor must be installed or removed in accordance with the usage mode. For
COOL,HEAT(heat pump type) or AUTO mode must be installed exhaust hose. For FAN, DRY or HEAT
(electrical heat type) mode must be removed exhaust hose.
control panel
remote signal receptor
horizontal louver control
(both sides)
lever(adjust manually)
NOTE: PHA can not be
adjusted.
vertical louver control
upper air intake
lever(adjust manually)
NOTE: PHA can not be
adjusted.
drain outlet
panel
lower air intake
bottom tray
drain outlet
Caster
MODE
Heat(pump heat
mode)
Heat(electrical
heat mode)
handle
air filter
air outlet
rear
Temperature Range
5-30°C (41-86°F)
≥
30°C (86°F)
Page 11
Page 15