Drive Clutch And Driven Clutch - Yamaha SR10ARLG Owner's Manual

3. Inspect the snowmobile to be used for
jump-starting to determine if voltage
and ground polarity are compatible.
The vehicle must have a 12-volt DC,
negative ground electrical system.
CAUTION
Always make sure the electrical
systems are of the same voltage
and ground polarity prior to con-
necting jumper
severe electrical
occur.
4. Move the vehicle to be used for the
jump-start close enough to ensure
the jumper cables easily reach; then
set and lock the brakes, shut off all
electrical accessories, and turn the
ignition switch OFF.

NOTE: Make sure all switches on
the snowmobile to be jump-started
are turned OFF.
5. Disconnect all external accessories
such as cell phones, GPS units, and
radios on both vehicles.
CAUTION
Failure to disconnect electronic
accessories during jump-starting
may cause system damage due to
power spikes.
6. Attach one clamp of the positive
(red) cable to the positive (+) termi-
nal (1) of the dead battery (C) being
careful not to touch any metal with
the other clamp; then attach the
other clamp of the positive (red)
cable to the positive (+) terminal (2)
of the good battery (B).
A. Unpainted Surface on Engine
B. Good Battery
C. Dead Battery
4
A
cables. If not,
damage may
3 2
B
1
C
0744-527

NOTE: Some jumper cables may
be the same color but the clamps or
ends will be color-coded red and
black.
7. Attach one clamp of the negative
jumper cable (black) to the negative
(-) terminal (3) of the good battery
(B); then attach the other clamp of
the negative (black) jumper cable (4)
to an unpainted metal surface (A) on
the engine or frame well away from
the dead battery and fuel system
components.
WARNING
Never make the final connection to a
battery as a spark could ignite hydro-
gen gases causing an explosion of the
battery resulting in acid burns or
blindness.
8. Stand well away from the dead bat-
tery and start the vehicle with the
good battery. Allow the vehicle to
run for several minutes applying
some charge to the dead battery.
9. Start the snowmobile with the dead
battery and allow it to run for several
minutes before disconnecting the
jumper cables.
10. Remove the jumper cables in oppo-
site order of hook-up (4, 3, 2, 1). Be
careful not to short cables against
bare metal.

NOTE: Have the battery and elec-
trical system checked prior to
operating the snowmobile again.
Drive Clutch and Driven
Clutch
The drive clutch and driven clutch do not
require lubrication; therefore, no special
maintenance is required by the snowmo-
bile owner except for periodical cleaning.
However, the drive clutch and driven
clutch should be disassembled, cleaned,
and inspected by an authorized Yamaha
Snowmobile dealer after every 4000 km
(2500 miles) or seasonally, whichever
occurs first. This service is at the discretion
and expense of the snowmobile owner.
10