Table of Contents
Advertisement
Handlebar Tilt
(Mountain Models)
1. Loosen the four cap screws and tilt
the handlebar to the desired position.
Machine Screws
2. Tighten the four cap screws evenly
to 15 ft-lb.
WARNING
Tighten the cap screws according
to specifications to prevent unex-
pected "movement" of the handle-
bar during operation over rough
terrain. DO NOT position handlebar
so steering (maximum right/left
turning capabilities) or throttle and
brake controls are affected.
Handlebar Tilt (SR10 Models)
The handlebar can be adjusted to the
operator's preference. To adjust the han-
dlebar, use the following procedure:
1. Remove the handlebar cover; then
loosen the eight cap screws securing
the handlebar caps to the riser and the
riser to the steering post.
0748-905
Exhaust System
The exhaust system is designed to reduce
noise and to improve the total perfor-
mance of the engine. If any exhaust sys-
tem component is removed from the
engine and the engine is run, severe
engine damage will result.
Air-Intake Silencer
Used in conjunction with the fuel intake
system is a specially designed air-intake
silencer. The purpose of the silencer is to
quiet the intake of fresh air. Since the fuel
intake system is calibrated with the air-
intake silencer in place, the engine must
never be run with the silencer removed.
Performance will not be improved if the
air-intake silencer is removed. In con-
trast, severe engine damage will occur.
Cap Screws
Cap Screws
0747-828
2. Adjust the handlebar to operator's
desired position, tighten the cap
screws evenly to 2.0 kg-m (15 ft-lb),
and check steering for maximum
right/left turning capabilities.
CAUTION
Do not rotate the handlebar to a
position that allows air to enter the
brake system.
WARNING
Tighten cap screws according to
specifications
to
pected "movement" of the handle-
bar during operation over rough
terrain. DO NOT position the han-
dlebar so steering (maximum right/
left turning capabilities) or throttle
and brake controls are affected.
CAUTION
These
snowmobiles
designed to be operated in dusty
conditions. Operating the snowmo-
bile in dusty conditions will result
in severe engine damage.
prevent
unex-
are
not
8
Advertisement
Table of Contents
