Table of Contents
Advertisement
NOTE: If battery posts or cable
ends have a build-up of white/
green powder residue, apply water
and baking soda to neutralize acid;
then flush off with warm soapy
water.
CAUTION
Do not remove seal strip on a
sealed battery.
WARNING
Battery acid is harmful if it contacts
eyes, skin, or clothing. Care must
be taken whenever handling a bat-
tery.
5. Using a multimeter, test the battery
voltage. The meter must read no less
than 12.5 DC Volts for a fully
charged battery.
NOTE: At this point if the meter
reads as specified, the battery may
be returned to service (see step 9).
6. If the meter reads less than specified
voltage, charge the battery using the
following guidelines.
A. When using an automatic battery
charger, always follow the char-
ger manufacturer's instructions.
B. When using a constant-current
battery charger, use the follow-
ing Battery Charging Chart.
CAUTION
Never exceed the standard charg-
ing rate.
WARNING
An
overheated
explode causing severe injury or
death. Always monitor charging
times and charge rates carefully.
Stop
charging
becomes very warm to the touch.
Allow it to cool before resuming
charging.
battery
could
if
the
battery
Battery Charging Chart
(Constant-Current Charger)
Battery
Charge
Voltage
State
(DC)
12.5 (mini-
100%
mum)
12.2-12.4
75%-99%
12.0-12.2
50%-74%
11.0-11.9
25%-49% 13 hours (minimum)
11.5 or less
0-24%
NOTE: If the battery voltage is
11.5 DC Volts or less, some char-
gers may "cut off" and fail to
charge. If this occurs, connect a
fully charged booster battery in
parallel (positive to positive and
negative to negative) for a short
period of time with the charger
connected. After 10-15 minutes,
disconnect the booster battery
leaving the charger connected and
the charger should continue to
charge. If the charger "cuts off,"
replace the battery.
7. After charging the battery for the
specified time, remove the battery
charger and allow the battery to sit
for 1-2 hours.
8. Connect the multimeter and test the
battery voltage. The meter should
read no less than 12.5 DC Volts. If
the voltage is as specified, the bat-
tery is ready for service.
NOTE: If voltage in step 8 is
below specifications, charge the
battery an additional 1-5 hours;
then retest. The battery is ready for
service.
9. Place the battery into position in the
snowmobile; then coat the battery
posts and cable ends with a light
coat of multi-purpose grease.
CAUTION
Before installing the battery, make
sure the ignition switch is in the
OFF position.
Charge Time
Required (at 1.5-
2.0 Amps)
None
3-6 hours
5-11 hours
20 hours (minimum)
26
Advertisement
Table of Contents
