Drive Guard - Yamaha FX Nytro FX10A Owner's Manual

1. Pull out.
2. Slide to "REV" (reverse).
3. Push in.
ECS00072
NOTICE
Do not use the shift lever while the snow-
mobile is moving, otherwise the drive train
could be damaged.
ESU12735

Drive guard

EWS00402
WARNING
Coming in contact with the rotating V-
G
belt or clutch parts can cause severe in-
jury or death. Never run the engine with
the drive guard removed.
Make sure that the drive guard is in-
G
stalled securely before operating the
snowmobile to protect against severe
injury or death from a broken V-belt or
other part should it come off the snow-
mobile while it is in operation.
ECS00830
NOTICE
Never run the engine with the V-belt re-
moved. Clutch components can be dam-
aged.
The drive guard is designed to protect the V-
belt clutch and V-belt in case parts break or
come loose.
Control functions
The drive guard is located behind the left side
cover. (See page 50 for removal procedures.)
To remove the drive guard
1. Pull out the drive guard locking pin from
the drive guard rear holder.
1. Drive guard
2. Drive guard locking pin
2. Lift up the rear of the drive guard as
shown, and then pull the guard rearward
to remove it.
To install the drive guard
1. Fit the front slots in the drive guard over
the projections on the drive guard front
holder.
1
2
17