Table of Contents
Advertisement
Installing the Hardware
3
Power down the system, disconnect the drives from the 7/8000
controller and remove the controller from the system.
4
Attach the drives to the 9000 controller, as described earlier in
this section.
Finishing Up
After you have installed the controller in the computer and attached
appropriate cables to the controller and drives, complete the
following steps to complete the hardware installation.
Check your Installation and Close the Case
1
Verify that the cables do not interfere with the operation of any
other components in the case or block the flow of cooling air.
2
Close the case and reconnect the power cables.
Configure your RAID Arrays
Turn to "Configuring Units" on page 27 for information about
configuring the RAID arrays.
22
3ware 9000 Series Serial ATA RAID Controller Installation Guide
Hide quick links:
Advertisement
Table of Contents
