Appendix A. Installing The Battery Backup Unit - 3Ware 9500S-4LP Installation Manual

Appendix A. Installing
the Battery Backup Unit
The Battery Backup Unit (BBU) is an add-on that can be attached
to a 3ware 9000 RAID controller to supply power to the memory
module from an attached battery pack in the event of a system
power loss. This allows the controller to use write-caching for
optimal performance and not be exposed to data loss in the event of
a system power failure. When fully charged, the battery preserves
the contents of the controller cache memory for a limited period of
time (up to 72 hours). When power is restored, cached data is
flushed to disks.
Caution:
Battery Backup Unit are sensitive electronic equipment
and can be damaged through electrostatic discharge.
When installing the BBU on the controller, be sure you
are grounded. Use a grounding strap, or work on an
ESD-protective mat.
Do not remove the 3ware controller or BBU from their
protective bags until you are properly grounded.
Handle the 3ware RAID controller by its edges or by
the black rail and metal bracket at its two ends.
Do not touch any pin, contact, lead, or component on
the 3ware RAID controller.
Important:
The cooler the battery, the longer the battery lasts. If
possible, place the controller with the BBU in a slot with
good airflow, away from components that generate the
most heat in the system, such as video cards.
www.3ware.com
Both the 3ware RAID controller and the
The battery is a heat-sensitive component.
99