If You Have Accidentally Triggered The Alarm System; Arming The System - Subaru 2005 Legacy Owner's Manual

Keys and doors
To activate:
Repeat moving the door locking switch to the lock po-
sition (toward the front) three times. The odometer/trip
meter screen will display "AL ON".
When the setting has been successfully changed, a
buzzer will sound and the odometer/trip meter screen
will display the new setting.
NOTE
You may have the above setting change done by
your SUBARU dealer.
! If you have accidentally triggered the
alarm system
! To stop the alarm
Do any of the following operations:
" Insert the key in the door lock of the driver's door
and turn it to the unlock position.
" Press any button on the remote transmitter.
" Turn the ignition switch to the "ON" position (only
vehicle with immobilizer).
" Cycle the ignition switch from the "LOCK" to "ON"
position three times within 5 seconds (only vehicle
without immobilizer).
2-24

! Arming the system

! To arm the system using remote transmitter
1. Close all windows and the moonroof (if so
equipped).
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood (and the trunk lid)
are locked.
5. Close all doors (and the rear gate on the Station
wagon).
: Press to Arm the system.
: Press to Disarm the system.