Windshield Wiper Blade Rubber - Subaru 2005 Legacy Owner's Manual

A) Stopper
3. Remove the wiper blade assembly by holding its
pivot area and pushing it in the direction shown by the
arrow while depressing the wiper blade stopper.
4. Install the wiper blade assembly to the wiper arm.
Make sure that it locks in place.
5. Lower the windshield wiper arm on the passenger's
side slowly while supporting it by hand.
6. Next, lower the windshield wiper arm on the driver's
side slowly while supporting it by hand.

! Windshield wiper blade rubber

A) Metal support
1. Grasp the locked end of the blade rubber assembly
and pull it firmly until the stoppers on the rubber are
free of the metal support.
Maintenance and service
– CONTINUED –
11-61