Turn And Lane-Change Signals; Headlamp High/Low-Beam Changer; Flash-To-Pass; Windshield Wipers - Pontiac 2009 Vibe Owner's Manual

Turn and Lane-Change
Signals
An arrow on the instrument panel
cluster flashes in the direction of the
turn or lane change.
Move the lever all the way up or
down to signal a turn.
Raise or lower the lever until the
arrow starts to flash to signal a lane
change. Hold it there until the
lane change is completed.
The lever returns to its starting
position whenever it is released.
If after signaling a turn or a
lane change the arrow flashes
rapidly or does not come on,
a signal bulb may be burned out.
Have the bulbs replaced. If the bulb
is not burned out, check the fuse.
See Fuses and Circuit Breakers
on page 9-36.
Headlamp High/
Low-Beam Changer
The headlamps must be on for this
feature to work.
Push the turn signal lever away
from you to turn the high beams on.
This instrument panel cluster light
3
comes on while the high beam
headlamps are on.
Pull the lever towards you to return
to low beams.

Flash-to-Pass

This feature is used to signal to the
vehicle ahead that you want to pass.
With the lever in the low-beam
position, pull the lever toward you to
momentarily switch to high-beams.
If the headlamps are on when the
lever is released, the high-beams will
return to low-beam.
Instruments and Controls

Windshield Wipers

The windshield wiper/washer lever
is located on the right side of
the steering column.
Move the lever to one of the
following positions:
z
(Mist): Move the lever to mist,
for a single wiping cycle and then
release. The wipers stop after
one wipe.
(
(Off): Move the lever to this
position to turn the wipers off.
4-7