Pontiac 2009 Vibe Owner's Manual page 119

Playing a CD
The CD player can play the smaller
3 inch (8 cm) single CDs with an
adapter ring.
1. Insert a CD label side up
partway into the slot.
2. The CD player pulls the CD in
and begins playing.
3. The CD symbol and track
number displays.
4. The CD stays in the player if the
ignition or radio is turned off.
5. If the CD was the last source
selected, it resumes playing
when the radio is turned on.
Y (EJECT): Press and release to
eject a CD. Once ejected it can be
removed. If the CD is not removed
after several seconds the CD player
automatically pulls the disc back into
the player and starts playing.
TUNE ADJ: Turn the TUNE ADJ
knob to select tracks on the CD.
y z
SEEK TRACK : Press
go to the start of the current
track, if more than ten seconds
z
have played. Press to go to the
next track. Holding or pressing
y z
or multiple times causes the
player to continue moving backward
or forward through the tracks on
the CD.
( )
FWD REV (Fast Forward/
Fast Reverse): Press and hold
to advance playback quickly within a
track. Release to resume playing the
)
track. Press and hold
playback quickly within a track.
Release to resume playing the track.
BAND: Press to listen to the radio
when a CD is playing.
CD/AUX (CD/Auxiliary): Press to
play a CD when listening to the radio.
y
to Press the CD/AUX button again and
the system begins playing audio from
the connected portable audio player.
If a portable audio player is not
connected, "No Input Device Found"
displays.
See "Using the Auxiliary Input Jack"
later in this section.
INFO (Information): Press to
switch the display between the
track number, elapsed time of the
(
track, and the time. When the
ignition is off, press this button to
display the time.
to reverse
EQ (Equalization): Press to select
an equalization setting while playing
a CD. See "EQ" listed previously for
more information. If an EQ setting is
selected for a CD, it is activated each
time a CD is played.
Infotainment 6-7