Pontiac 2009 Vibe Owner's Manual page 69

Arming the System
To arm the system:
1. Close all the doors and the
liftgate.
2. Lock the doors and liftgate with
the key or Remote Keyless
Entry (RKE) transmitter.
The security light comes on solid.
The system automatically arms
after 30 seconds. The security
light flashes when the system
is armed.
No one should be in the vehicle
when the alarm system is armed
because unlocking the vehicle from
the inside activates the system.
To avoid setting off the alarm make
sure all passengers are out of
the vehicle and the windows are
closed before arming the system.
Disarming the System
To disarm the alarm do one of the
following:
•
Unlock the doors with the key.
•
Unlock the doors and liftgate with
the RKE transmitter.
•
Start the engine.
Testing the Alarm
To test the alarm:
1. Open all the windows.
2. Set the system as described
in the previous procedure.
The doors and liftgate should
be locked with the key or RKE
transmitter. Be sure to wait until
the security light starts flashing.
3. Unlock the driver door from the
inside. The system should
activate the alarm.
4. Stop the alarm as described in
the disarming procedure.
5. Repeat this operation for the
other doors. Also, check that
the system is activated when the
battery terminal is disconnected
and then reconnected.
Keys, Doors and Windows
If the system does not work
properly, have it checked by your
dealer/retailer.
How the System Alarm is
Activated
The system activates the alarm if:
•
A locked door or the liftgate is
unlocked or opened without the
RKE transmitter.
•
A locked door is unlocked or
opened without the key.
•
The liftgate is unlocked or opened
with the key.
•
The battery is reconnected.
•
The side windows are tapped or
broken.
Do not leave the key or device that
disarms or deactivates the theft
deterrent system in the vehicle.
2-11