Table of Contents
Advertisement
Innovative Hearth Products
DRT3000 Series Direct-Vent Gas Fireplaces
6. If a wall-mounted ON/OFF control, High/Low switch, or thermostat is to be used, mount it in a convenient location on a wall
7. If an optional control is to be used, wire it in the low voltage circuit (Figures 30-31).
8. After the wiring is complete, replace the cover plate.
Electronic models of these appliances are equipped with a three-prong (grounding)
plug utilized in connecting the electronic components to the junction box in the lower
compartment. This grounding plug provides protection against shock hazard and should be
plugged directly into a properly grounded three-prong receptacle. DO NOT cut or remove the
grounding prong from the plug.
Install the [Optional] Blower Kit after Installation in the Framing
13.
NOTE: For steps 11 and 12, it may be helpful to remove the control compartment door (Page 52).
FBK-100, FBK-200, and FBK-250 Kits
An electrical outlet box is provided for the installation of the FBK-100, FBK-200, and
Electrical power must be provided to the box to operate the blower. Install the blower kit according to the installation
instructions provided with the kit.
NOTE: The tab connecting the receptacles of the outlet box must be broken in FBK-100 and FBK-200 blower kit
applications (Figure 32).
40
near the fireplace.
NOTE: The supplied 15 ft of 2-conductor wire has one end of each conductor connected to the gas valve circuit
and the other end of each conductor placed loose inside the bottom compartment.
WARNING
Installation
900684-01 06/2018
FBK-250
forced air blower kits.
Hide quick links:
Advertisement
Table of Contents
